Applicable LEED Credits:

Materials & Resources (MR) Credit 1.2 - Building Reuse - Maintain Existing Interior Non-Structural Elements

Extend the lifecycle of existing building stock, conserve resources, retain cultural resources, reduce waste and reduce environmental impacts of new buildings as they relate to materials manufacturing and transport. The longevity and durability of openings created with products from ASSA ABLOY Group brands should allow re-use on LEED projects and help in the attainment of this credit.

BARON - CECO DOOR - CURRIES - FRAMEWORKS - GRAHAM - MAIMAN - SMP SPECIALTY DOORS

Materials & Resources (MR) Credit 4 - Recycled Content

Increase demand for building products that incorporate recycled content materials, thereby reducing impacts resulting from extraction and processing of virgin materials. Use materials with recycled content such that the sum of post consumer recycled content plus 1/2 of the preconsumer content constitutes at least 10% or 20%, based on cost, of the total value of the materials in the project. The recycled content value of a material assembly is determined by weight. The recycled fraction of the assembly is then multiplied by the cost of assembly to determine the recycled content value. Almost all products from ASSA ABLOY Group brands contain recycled content and contribute toward this credit.

ADAMS RITE- BARON - CECO DOOR - CORBIN RUSSWIN - CURRIES - FRAMEWORKS - GRAHAM - HES - MAIMAN - MARKAR - McKINNEY - MEDECO - NORTON - PEMKO - RIXSON - ROCKWOOD - SARGENT - SECURITRON - SMP SPECIALTY DOORS - YALE

Materials & Resources (MR) Credit 5 - Regional Material

Increase demand for building materials and products that are extracted and manufactured within the region, thereby supporting the use of indigenous resources and reducing the environmental impacts resulting from transportation. Use building materials or products that have been extracted, harvested or recovered, as well as manufactured, within 500 miles of the project site for a minimum of 10% or 20%, based on cost, of the total materials value. Manufacturing facilities for ASSA ABLOY Group brands are located throughout North America and can assist your projects in earning this credit.

ADAMS RITE - BARON - CECO DOOR - CORBIN RUSSWIN - CURRIES - FRAMEWORKS - GRAHAM - HES - MAIMAN - MARKAR - McKINNEY - MEDECO - NORTON - PEMKO - RIXSON - ROCKWOOD - SARGENT - SECURITRON - SMP SPECIALTY DOORS - YALE

Indoor Environmental Quality (IEQ) Credit 4.1 & 4.2 - Low-Emitting Materials: Adhesives & Sealants, Paints & Coatings

Reduce the quantity of indoor air contaminants that are odorous, irritating and/or harmful to the comfort and well-being of installers and occupants. This credit only applies to materials applied within the weatherproofing system. ASSA ABLOY Group brands, however, offer solutions including pre-finished door openings and pre-installed glazing. This allows LEED projects to avoid applying materials onsite.

ADAMS RITE - BARON - CECO DOOR - CORBIN RUSSWIN - CURRIES - FRAMEWORKS - GRAHAM - HES - MAIMAN - MARKAR - McKINNEY - MEDECO - NORTON - PEMKO - RIXSON - ROCKWOOD - SARGENT - SECURITRON - SMP SPECIALTY DOORS - YALE

 

Indoor Environmental Quality (IEQ) Credit 8.1 & 8.2 - Daylights & Views

Provide building occupants with a connection between indoor spaces and the outdoors through the introduction of daylight and views into the regularly occupied areas of the building. Adding glazing and sidelights to openings built with products from ASSA ABLOY Group brands will assist projects in achieving this LEED credit.

BARON - CECO DOOR - CURRIES - FRAMEWORKS - GRAHAM - MAIMAN - PEMKO - SMP SPECIALTY DOORS